Follow this link for a Google Slide Deck of the assembly instructions. 

For more information on the PocketLab HotRod, click here. 

Finished PocketLab Hot Rod
 

Slide bearing mounts into the slots in the car base
 

Slide ball bearings into the mount from the outside of the car
 

Slide O-rings over the outside of the wheels
 

Screw threaded axle rod into the wheel



Place washers on threaded axle as spacer and insert axle through the ball bearings



 

Place washer on outside of bearing and thread other wheel onto axle. Tighten to finger strength.

DO NOT OVERTIGHTEN!

Snap bumper or other mounting accessories into the top platform of the base



Push the C-shaped part over the rear axle to create a rubber band car

Other notes
 

• Do not overtighten the wheels when threading onto the axle rod!

• The holes in the car base are designed for 5/16 inch bolts and screws

• Lessons and activities for the PocketLab HotRod can be found on our community website at www.thepocketlab.com/support